1.	Screw in the two 16x25 self-taping screws on a same horizontal level at a distance of 6.75 inches (170 mm) from eachother in the wall.
2.	Hang the purifier on the wall with the help of wall mounting holes present on the back side of the purifier as shown in the figure.
3.	Fix the SS ball valve to the ¼ inch port of the 3-way connector as shown in the figure.
4.	Connect the 3-way connector (Diverter Valve) to the raw water supply as shown in the figure.
5.	Now connect one end of the white pipe to the SS ball valve and other end to the lower push fit elbow fitting on the left hand side of the purifier labeled as WATER IN. (Note : White pipe is for raw water supply)
7.	Similarly, connect one end of the blue pipe to the upper elbow fitting connector labeled as REJECT WATER and leave the other end in the drain. (Note : Blue pipe is for reject water)
8.	Before connecting the power supply perform the following functions:

• Open the SS ball valve to start the flow of water into the purifier.
• Wait for 2-3 minutes to release the air from filter housing.